PENGARUH ARUS DAN WAKTU TERHADAP LAPISAN ZINC PLATING PADA MATERIAL ASTM A36 DENGAN MENGGUNAKAN PROSES ELEKTROPLATING

Wibisono, Gusti Adi (2022) PENGARUH ARUS DAN WAKTU TERHADAP LAPISAN ZINC PLATING PADA MATERIAL ASTM A36 DENGAN MENGGUNAKAN PROSES ELEKTROPLATING. Sarjana (S1) thesis, Universitas Islam "45" Bekasi.

	Text PENDAHULUAN.pdf Download (924kB)
	Text BAB I.pdf Download (194kB)
	Text BAB II.pdf Restricted to Repository staff only Download (158kB) | Request a copy
	Text BAB III.pdf Restricted to Repository staff only Download (604kB) | Request a copy
	Text BAB IV.pdf Restricted to Repository staff only Download (1MB) | Request a copy
	Text BAB V.pdf Download (60kB)
	Text DAFTAR PUSTAKA.pdf Download (69kB)

Abstract

Corrosion is one of the problems that is often found in industry, especially in materials containing iron or carbon steel. And How to Stop Corrosion in Materials by Using Materials with Zinc Coating. This zinc plating layer is an alternative for the automotive industry because in addition to the cost of materials that are cheap, easy, and very easy in the process. This research was conducted to find the ideal current and time used during the plating process, because in every industry the most frequent problems are the thickness that coats the material and the corrosion rate of the material that causes the material to become damaged or no good. This study uses ASTM A36 carbon steeland zinc as a coating. The research was carried out on a tank containing various kinds of chemical liquids and using electric current as conductivity for the coating media. Analysis using layer thickness measurement using dial thickness gauge measuring instrument and weight loss method. The results obtained from searching the current and the ideal time using a current of 900 A and a time of 60 minutes is 0.015 mm or 15 μm thick and the SST test (Salt Spray Test) at 96 hoursNo White Rust and 144 Hours No Red Rust.

Actions (login required)

View Item